Syntax
Call the command without parameters:
shutdown complete
Result
The Interface is shut down.
Note
If you use this command in the Interface Configuration mode for a VLAN (input prompt
CLI(config-if-vlan-$)#, management access to the device is no longer possible. This
relates to configuration using CLI, WBM and SNMP. Access is only possible again after
resetting the device to the factory settings with the Reset button.
Further notes
You activate the interface with the no shutdown command.
You can display the status of this function and other information with the show
interfacescommand.
4.1.11.9 no shutdown
Description
With this command, you shut down an interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no shutdown
Result
The Interface is activated.
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 81
To Next Page
Loading...
Need help?
General
