11.5.4.2 no ip access-group
Description
With this command, you disable the access control of the packets of a VLAN.
Requirement
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ip access-group [<access-list-number(1-20)>]{in|out}
The parameters have the following meaning:
Parameter Description Range of values / note
access-list-
number
Number of the access control list 1 ... 20
in Specifies that incoming packets are fil‐
tered
-
out Specifies that outgoing packets are fil‐
tered
-
If you do not specify a number for an access control list, all lists of a VLAN are disabled.
Result
The packet filtering according to the access control list (ACL) is canceled.
Further notes
You enable the setting with the ip access-group command.
You display the configuration of the access control list with the show access-lists
command.
11.5.5 Commands in the ACL standard configuration mode
This section describes commands that you can call up in the ACL standard configuration mode.
Security and authentication
11.5 IP access control list
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 561
To Next Page
Loading...
Need help?
General
