Syntax
Call the command without parameters:
mac-address-table aging
Result
The "Aging" function is enabled.
Further notes
You configure the time with the mac-address-table aging-time command.
You disable the "Aging" function with the no mac-address-table aging command.
7.2.2.2 no mac-address-table aging
Description
With this command, you disable the "Aging" function.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no mac-address-table aging
Result
The "Aging" function is disabled.
Further notes
You enable the "Aging" function with the mac-address-table aging command.
Network structures
7.2 VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
286 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
