11.5.1.1 show access-lists
Description
This command shows the configuration of the access control lists (Access Control List).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show access-lists [ [{ip | mac}] <access-list-number (1 - 20)> ]
The parameters have the following meaning:
Parameter Description Range of values / note
ip Selects IP-based access lists (IP ACL) -
mac Selects MAC-based access lists (MAC
ACL)
-
access-list-
number
Number of the access control list 1 ... 20
If you do not select any parameters from the parameter list, the configuration of all access
control lists will be displayed.
Result
The configuration of the access control lists is displayed.
11.5.1.2 show interface access lists
Description
This command shows the access control list of one or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Security and authentication
11.5 IP access control list
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
554 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
