Result
The counters of the selected interfaces are displayed.
4.1.1.8 show interface mtu
Description
With this command, you show the setting for the Maximum Transmission Unit (MTU) of the
interfaces on the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show interface mtu [{vlan<vlan-id(1-4094)>|
<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
If no parameters are specified, the settings for all interfaces are displayed.
Result
The settings are displayed.
4.1.1.9 show ip interface
Description
This command shows the configuration of one, several or all IP interfaces.
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
54 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
