6.3.3.4 sntp client addressing-mode
Description
With this command, you configure the addressing mode of the SNTP client as unicast or
broadcast.
Requirement
● The SNTP client is activated.
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp client addressing-mode{unicast|broadcast}
The parameters have the following meaning:
Parameter Description Range of values / note
unicast configures the SNTP client in unicast
mode
Default: unicast enabled
broadcast configures the SNTP client in broadcast
mode
Supports only IPv4 addresses
Result
The addressing mode of the SNTP client is configured.
Further notes
You display this setting and other information with the show sntp status command.
You display the settings for the unicast mode with the show sntp unicast-mode
status command.
You display the settings for the broadcast mode with the show sntp broadcast-mode
status command.
System time
6.3 SNTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 183
To Next Page
Loading...
Need help?
General
