7.1.5.45 wlan ssid-table edit (client)
Description
With this command, you change or delete an entry in the SSID list.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan ssid-table edit <index (1-8)> {enable | disable| delete} [ssid]
The parameters have the following meaning:
Parameters Description Range of values / note
index Index entry in the SSID list 1...8
enable Entry is used --
disable Entry is not used Default
delete Entry is deleted. The ssid param‐
eter is ignored.
--
ssid SSID Enter the SSID of the access point.
The length of the character string for SSID is
1 to 32 characters. ASCII code 0x20 to 0x7e
is used for the SSID.
To be able to use spaces in the SSID, enter
the SSID in quotes:
wlan ssid-table edit "H a l l o"
Result
The corresponding index entry in the SSID list is changed or deleted.
Further notes
You display the list with the show wlan ssid-table <wlan 0/X> command.
You delete an SSID entry with the wlan ssid-table edit <index (1-8)> delete
command.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
248 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
