Further notes
You configure the e-mail name of the sender with the sender mail-address.
You display the setting with the show events sender email command.
8.7.2.5 smtp-port
Description
With this command, you configure an SMTP port.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
smtp-port <smtp-port(1-65535)>
The parameter has the following meaning:
Parameter Description Range of values / note
smtp-port Value for the SMTP port 1 ... 65535
Default: 25
Result
An SMTP port is configured.
Further notes
You can reset the setting to the default with the no smtp-port command.
You display the setting with the show smtp-port command.
8.7.2.6 no smtp-port
Description
With this command, you reset the SMTP port to the default.
The default value is 25.
Network protocols
8.7 SMTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 441
To Next Page
Loading...
Need help?
General
