You display the setting with the show ipv6 dhcp interface command.
You display the statistics with the show ipv6 dhcp client statistics command.
8.4.2 The "show" commands
This section describes commands with which you display various settings.
8.4.2.1 show ipv6 dhcp
Description
This command shows the DHCPv6 configuration.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ipv6 dhcp
Result
The configuration is displayed.
8.4.2.2 show ipv6 dhcp interface
Description
This command shows the DHCPv6 configuration and the DHCPv6 information that was
received from the DHCPv6 server.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Network protocols
8.4 DHCPv6 client (IPv6)
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 383
To Next Page
Loading...
Need help?
General
