Result
The IP ARP table is displayed.
8.11 SSH server
This section describes commands of the Secure Shell (SSH) Server.
8.11.1 The "show" commands
This section describes commands with which you display various settings.
8.11.1.1 show ip ssh
Description
This command shows the settings of the SSH server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip ssh
Result
The settings for the SSH server are displayed.
8.11.2 Commands in the Global Configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
Network protocols
8.11 SSH server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 447
To Next Page
Loading...
Need help?
General
