Functions specific to SCALANCE
5
This part contains the sections that describe functions specific to SCALANCE.
5.1 PLUG
The C-PLUG or KEY-PLUG stores the configuration of a device and can therefore transfer the
configuration of the old device to the new device when a device is replaced.
In addition to the configuration, the KEY-PLUG also contains a license that enables the use
of certain functions.
This section describes commands relevant for working with the C-PLUG or KEY-PLUG.
5.1.1 The "show" commands
This section describes commands with which you display various settings.
5.1.1.1 show plug
Description
This command shows the current information of the PLUG.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show plug
Result
The current information of the PLUG is diplayed.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 109
To Next Page
Loading...
Need help?
General
