Network protocols
8
This part contains the sections that describe the commands for working with the various
network protocols.
8.1 IPv4 protocol
This section describes commands of the Internet Protocol (IP) version 4.
8.1.1 The "show" commands
This section describes commands with which you display various settings.
8.1.1.1 show dcp forwarding
Description
This command shows an overview of the DCP forwarding behavior on one or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show dcp forwarding [port<interface-type><interface-id>]
The parameters have the following meaning:
Parameter Description Range of values / note
port Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 341
To Next Page
Loading...
Need help?
General
