11.4.2.2 no mac access-list extended
Description
With this command, you delete a MAC access control list.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac access-list extended<short(1-20)>
The parameter has the following meaning:
Parameter Description Range of values / note
short Number of the access control list 1 ... 20
Result
The MAC access control list is deleted.
Further notes
You generate a MAC ACL with the mac access-list extended command.
You display the configuration of the access control list with the show access-lists
command.
11.4.3 Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
Security and authentication
11.4 MAC access control list
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
548 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
