Result
The encryption is disabled.
Further notes
You display the settings with the show wlan security command.
You enable the encryption with the wlan security encryption command.
See also
wlan security encryption (client) (Page 522)
wlan security authentication (client) (Page 514)
11.3.4.11 wlan security wpa-psk-passphrase (client)
Description
With this command, you store the WPA(2) key that is used in WPA-PSK and WPA2-PSK
authentication.
Note
The key can be 8 to 63 ASCII characters or exactly 64 hexadecimal characters long. It should
be selected so that is complex for example consisting of random numbers, letters (upper-/
lowercase), have few repetitions and special characters. Do not use known names, words or
terms that could be guessed. If a SCALANCE W700 device is lost or if the key becomes known,
the key should be changed on all SCALANCE W700 devices to maintain security.
Note
This command is only available in the client mode.
Requirement
● WPA-PSK, WPA2-PSK or WPA(2)-PSK auto is set for the type of authentication.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Syntax
Call up the command with the following parameters:
wlan security wpa-psk-passphrase <string>
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
524 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
