Result
The current configuration of the TFTP server for Load&Save is displayed.
4.2.2 save filetype
Description
With this command, you save files on a TFTP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
save filetype <filetype> tftp {ipv4 <ucast_addr> | fqdn-name <FQDN>
| ipv6 <ip6_addr>} [port <tcpport (1-65535)>] file <filename>
The parameters have the following meaning:
Parameter Description Range of values / note
filetype Keyword for a file type to be loaded -
filetype Name of the file type Maximum of 100 characters
tftp Keyword for a TFTP server -
ipv4 Keyword for an IPv4 address
ucast_addr IPv4 unicast address of the TFTP server Enter a valid unicast IPv4 address.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Domain
Name) of the TFTP server
Maximum of 100 characters
ipv6 Keyword for an IPv6 address -
ip6_addr IPv6 address of the TFTP server Enter a valid unicast IPv6 address.
port Keyword for the port of the server via
which the TFTP connection runs
-
tcpport Number of the port 1 … 65535
file Keyword for a file name to be assigned -
filename Name of the file Maximum of 100 characters
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
For information on the file types , refer to this list (Page 82).
Configuration
4.2 Load and Save
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
86 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
