Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
11.4.2.1 mac access-list extended
Description
With this command, you generate a MAC access control list and change to the MAC ACL
configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac access-list extended<access-list-number(1-20)>
The parameter has the following meaning:
Parameter Description Range of values / note
access-list-
number
Number of the access control list 1 ... 20
Result
A MAC access control list has been generated.
You are now in the MAC ACL configuration mode.
The command prompt is as follows:
cli(config-ext-macl)#
Further notes
You delete the MAC access control list with the no mac access-list extended command.
You exit the MAC ACL configuration mode with the exit command.
You display the configuration of the access control list with the show access-lists
command.
Security and authentication
11.4 MAC access control list
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 547
To Next Page
Loading...
Need help?
General
