Result
The SNMP view is configured.
Further notes
You delete the view with the no snmp view command.
You display the configured SNMP tree views with the show snmp viewtree command.
You display the access rights of the SNMP groups with the show snmp group access
command.
You configure the access rights of the SNMP groups with the snmp accesscommand.
8.6.2.25 no snmp view
Description
With this command, you delete an SNMP view.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp view <ViewName> <OIDTree>
The parameters have the following meaning:
Parameter Description Range of values / note
ViewName Name of the view max. 32 characters
OIDTree Object ID Path information of the MIB tree
Result
The SNMP view is deleted.
Further notes
You configure a view with the snmp view command.
You display the configured SNMP tree views with the show snmp viewtree command.
Network protocols
8.6 SNMP
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 435
To Next Page
Loading...
Need help?
General
