The parameter has the following meaning:
Parameter Description Range of values / note
location name Input box for the location information max. 255 characters
Result
The location information is created in the system.
4.1.10.12 system name
Description
This command, you enter a name for the system.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
system name <system name>
The parameter has the following meaning:
Parameter Description Range of values / note
system name Input box for the name max. 255 characters
Result
The name is created in the system.
4.1.11 Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
74 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
