For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The following settings of the VAP are displayed:
● Admin status
● SSID
● Broadcast SSID
● WDS only
● WDS ID
7.1.1.20 show wlan wds (access point)
Description
This command shows the configuration of the WDS interface.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan wds <wdsX 0/Y>
The parameter has the following meaning:
Parameter Description Range of values / note
wdsX 0/Y WDS interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 201
To Next Page
Loading...
Need help?
General
