11.4.3.1 mac access-group
Description
With this command, you enable the access control of the packets of an interface.
Requirement
● A MAC access control list has been created.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
mac access-group <access-list-number(1-20)>{in|out}
The parameters have the following meaning:
Parameter Description Range of values / note
access-list-
number
Number of the access control list 1 ... 20
in Specifies that incoming packets are fil‐
tered
-
out Specifies that outgoing packets are fil‐
tered
-
Result
The packets are filtered according to the access control list (ACL).
Further notes
You disable the setting with the no mac access-group command.
You display the statistical data of the access control list with the show access-lists
command.
11.4.3.2 no mac access-group
Description
With this command, you disable the access control of the packets of an interface.
Security and authentication
11.4 MAC access control list
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 549
To Next Page
Loading...
Need help?
General
