Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no mac access-group <access-list-number(1-20)>{in|out}
The parameters have the following meaning:
Parameter Description Range of values / note
access-list-
number
Number of the access control list 1 ... 20
in Specifies that incoming packets are fil‐
tered
-
out Specifies that outgoing packets are fil‐
tered
-
Result
The packet filtering according to the access control list (ACL) is canceled.
Further notes
You enable the setting with the mac access-group command.
You display the configuration of the access control list with the show access-lists
command.
11.4.4 Commands in the MAC ACL configuration mode
This section describes commands that you can call up in the MAC ACL configuration mode.
In the Global configuration mode, enter the mac access-list extended command to
change to this mode.
● If you exit the MAC ACL configuration mode with the exit command, you return to the
Global configuration mode.
● If you exit the MAC ACL configuration mode with the end command, you return to the
Privileged EXEC mode.
Security and authentication
11.4 MAC access control list
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
550 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
