10.1.3.13 no nat timeout (Client)
Note
This command is only available in the client mode.
Description
With this command, you delete the time period for the TCP / UDP connection.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
no nat {tcp|udp} timeout
The parameters have the following meaning:
Parameters Description Range of values / note
tcp TCP connection -
udp UDP connection -
Result
The time period for the TCP / UDP connection was set to the default setting.
Further notes
You show the NAT configuration and the translation list with the show nat command.
You configure the time with the nat timeout command.
See also
show nat (Client) (Page 456)
Layer 3 functions
10.1 NAT
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 469
To Next Page
Loading...
Need help?
General
