See also
wlan security ap-radius-authenticator reauth-mode (Page 507)
show wlan security ap-radius-authenticator (Access Point) (Page 496)
11.3.2.9 wlan security ap-radius-authenticator reauth-mode
Description
With this command, you specify who decides the time before the clients are forced to
reauthenticate.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator reauth-mode {show-modes |
<mode>}
The parameters have the following meaning:
Parameters Description Range of values / note
show-modes Lists the available values.
● disabled
Function is disabled
● server
Time management on the server
● local
Local time management. You specify
the period of validity with the wlan
security ap-radius-
authenticator reauth-interval
command.
mode Method of time management
Result
The function is configured.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 507
To Next Page
Loading...
Need help?
General
