5.10.1 show remote capture
Description
This command shows the settings of remote capture of one or all interfaces.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show remote capture {<interface-type> <0/a-b,0/c,...> | all}
The parameters have the following meaning:
Parameter Description Range of values / note
interface-
type
Type or speed of the interface Specify a valid interface.
0/a-b,0/c,... Port no. of the interface
all Shows the settings of all interfaces. -
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The settings are displayed.
5.10.2 Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
Functions specific to SCALANCE
5.10 Remote capture
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
160 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
