11.3.1.3 show wlan security keys
Description
This command shows a table with the WEP key of the SCALANCE W700 device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan security-keys < wlan 0/X >
The parameters have the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The key table is displayed.
See also
wlan security edit key (Page 512)
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 497
To Next Page
Loading...
Need help?
General
