7.1.5.20 wlan background scan interval (client)
Description
With this command, you specify the Interval at which the client scans for further access points.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan background scan interval <ms(300-60000)>
The parameter has the following meaning:
Parameters Description Range of values / note
ms Time in milliseconds (ms) 300 ... 60 000
Default: 5000
Result
The interval is specified.
Further notes
You show the set interval with the show wlan client <wlan 0/X> command.
7.1.5.21 wlan background scan mode (client)
Description
With this command, you specify how the client scans for further access points.
Note
This command is only available in the client mode.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
226 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
