In the Global configuration mode, enter the sntp command to change to this mode.
● If you exit the SNTP configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the SNTP configuration mode with the end command, you return to the Privileged
EXEC mode.
6.3.3.1 sntp time diff
Description
With this command, you configure the time difference of the system time relative to the UTC
time.
Requirement
● The SNTP server must have started up.
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp time diff <(+/-hh:mm)>
The parameter has the following meaning:
Parameter Description
+ Time zones to the west of the SNTP server time zone
- Time zones to the east of the SNTP server time zone
hh Number of hours difference
mm Number of minutes difference
Enter the time difference as follows:
● with sign
● without spaces
● Hours and minutes both two digits (with leading zero)
Default: no time difference
Result
The time zone of the system time is configured.
System time
6.3 SNTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
180 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
