Load control
9
This part contains the sections describing the functions for controlling and balancing network
load.
9.1 Dynamic MAC aging
The section describes commands with which the aging of dynamically learned entries is
configured in a MAC address list.
9.1.1 The "show" commands
This section describes commands with which you display various settings.
9.1.1.1 show mac-address-table aging-time
Description
To ensure that the address entries are up-to-date, MAC addresses are only kept in the address
table for a specified time.
This command shows the time after which the MAC addresses are removed from the address
table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show mac-address-table aging-time
Result
The time is displayed.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 451
To Next Page
Loading...
Need help?
General
