7.2.1.3 show mac-address-table dynamic unicast
Description
This command shows the MAC addresses of the dynamic unicast configuration.
Requirement
● In "base bridge-mode", the mode for the device is set to "transparent".
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show mac-address-table dynamic unicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type>
<interface-id>}]
The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN or VLAN range -
vlan-range Number of the addressed VLAN or VLAN range 1 ... 4094
address Keyword for a MAC address -
aa:aa:aa:aa:aa:
aa
MAC address -
interface Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries are displayed.
Network structures
7.2 VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 281
To Next Page
Loading...
Need help?
General
