Result
The assignment of the IP address to a VLAN interface is deleted and DHCP is disabled.
Note
Effectiveness of the command
The command is effective immediately.
If you configure the interface via which you access the device, you can lose the connection!
Further notes
You configure the setting with the ip address command.
You display this setting and other information with the show ip interface command.
8.1.3.3 ip address dhcp
Description
With this command, the VLAN interface obtains the IP address via DHCP.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameters:
ip address dhcp
Result
The DHCP assigns the IP address to the VLAN interface.
Further notes
You delete the settings with the no ip address command.
You display this setting and other information with the show ip interface command.
Network protocols
8.1 IPv4 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 357
To Next Page
Loading...
Need help?
General
