7.1.5.32 wlan data rate-11n (access point)
Description
With this command, you assign data transmission speeds to the required WLAN interface. The
access point will then use only the selected data transmission speeds for communication with
the clients.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
● The transmission standard IEEE 802.11n or IEEE 802.11n only is set.
● The "Use selected data rates only" function is enabled.
Syntax
Call up the command with the following parameters:
wlan data rate-11n { show-MCS-indexes | {add | del} <index> | all |
none }
The parameters have the following meaning:
Parameters Description
show-MCS-indexes Shows a list of the available data transmission speeds (MCS indexes).
add The MCS index is assigned to the WLAN interface entered in the
<index> parameter.
del The MCS index is removed from the WLAN interface entered in the
<index> parameter.
index MCS index
all All available MCS indexes are assigned to the WLAN interface.
none Only the first available MCS index is assigned to the WLAN interface. The
other MCS indexes are deselected.
Note
You need to enable at least one MCS index of the WLAN interface.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 237
To Next Page
Loading...
Need help?
General
