The parameters have the following meaning:
Parameters Description
show-rates Shows a list of the available data transmission speeds.
add The data transmission speed is assigned to the WLAN interface entered
in the <rate> parameter.
del The data transmission speed is removed from the WLAN interface en‐
tered in the <rate> parameter.
rate Data transmission speed
all All available data transmission speeds are assigned to the WLAN inter‐
face.
none Only the first available data transmission speed is assigned to the WLAN
interface. The other data transmission rates are deselected.
basic The data transmission speed entered in the <rate> parameter is de‐
clared as "Basic".
The "basic" parameter can only be called in conjunction with the param‐
eters "add", "del", "all" and "none".
Note
You need to assign at least one data transmission speed and one "Basic" to the WLAN
interface.
Result
The data transmission speeds are assigned to the WLAN interface.
Further notes
You display the setting with the show wlan data rates command.
You enable the function with the wlan data rates-11abg selected only command.
You configure the transmission standard with the wlan mode command.
You can reset the selection to the default setting with the wlan data rate-11abg
defaults command.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
236 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
