Parameter Description Range of values / note
- Enter the maximum number of retries
for an attempted query.
The initial connection attempt is repea‐
ted the number of times specified here
before another configured RADIUS
server is queried or the login counts as
having failed.
1 … 5
Default: 3 (retries, this means 4
connection attempts)
key Keyword for the key for communication
between the authenticator and the serv‐
er
-
secret-key-string Value for the key 128 characters
Default: "default"
primary Identifies the RADIUS server as primary
server
-
login The server is used only for the login au‐
thentication.
-
dot1x The server is used only for the 802.1X
authentication.
-
login-dot1x The server is used for both authentica‐
tion procedures.
Default setting
test Tests whether or not the specified RA‐
DIUS server is available. At the same
time you can create a new RADIUS
server and run the test.
-
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 29)".
If optional parameters are not specified when configuring, the default values apply.
Note
Primary server
In a network, only one RADIUS server can be selected as the primary server.
If you select a RADIUS server as the primary server, this replaces the server that previously
had the role of primary server.
Further notes
You store a domain name with the ip domain name or domain name command.
11.2.2.5 no radius-server
Description
With this command, you delete a RADIUS server entry on the RADIUS client.
Security and authentication
11.2 RADIUS client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 493
To Next Page
Loading...
Need help?
General
