8.2.2 The "show" commands
This section describes commands with which you display various settings.
8.2.2.1 show ipv6 neighbors
Description
This command shows IPv6 neighbors table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ipv6 neighbors
Result
The IPv6 neighbors table is displayed.
Further notes
You configure a static entry with the ipv6 neighbor command.
8.2.2.2 show ipv6 pmtu
Description
This command shows the settings for Path MTU.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Network protocols
8.2 IPv6 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 359
To Next Page
Loading...
Need help?
General
