Result
The file is saved on the TFTP server.
4.2.3 load tftp
Description
With this command, you load the files from a TFTP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
load tftp {ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>}
[port <tcp port (1-65535)>] file <filename> filetype <filetype>
The parameters have the following meaning:
Parameter Description Range of values / note
ipv4 Keyword for an IPv4 address
ucast_addr IPv4 unicast address of the TFTP server Enter a valid unicast IPv4 address.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Domain
Name) of the TFTP server
Maximum of 100 characters
ipv6 Keyword for an IPv6 address -
ip6_addr IPv6 address of the TFTP server Enter a valid unicast IPv6 address.
port Keyword for the port of the server via
which the TFTP connection runs
-
tcp port Number of the port 1 … 65535
file Keyword for a file name to be assigned -
filename Name of the file Maximum of 100 characters
filetype Keyword for the file type to be loaded -
filetype Name of the file type
Note:
With certificate files only certificates
with a maximum of 8192 bits are sup‐
ported.
Maximum of 100 characters
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Configuration
4.2 Load and Save
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 87
To Next Page
Loading...
Need help?
General
