Siemens SCALANCE W770 Series User Manual

Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call the command without parameters:
no ipv6 transparent mode
Result
The transparent mode is deactivated.
Further notes
You enable the transparent mode with the command ipv6 transparent mode.
10.1.3.3 nat (Client)
Note
This command is only available in the client mode.
nat
Description
With this command, you configure the translation list for communication from the global to the
local network.
A maximum of 60 entries are possible.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
Layer 3 functions
10.1 NAT
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 459

Siemens SCALANCE W770 Series Specifications

General

Brand	Siemens
Model	SCALANCE W770 Series
Category	Wireless Access Point
Language	English