Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
4.1.11.1 alias
Description
With this command, you assign a name to an interface. The name only provides information
and has no effect on the configuration.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
alias <interface-name>
The parameter has the following meaning:
Parameter Description Range of values / note
interface-name Name of the interface max. 63 characters
Result
The interface was assigned a name.
Further notes
You delete the name of the interface with the no alias command.
4.1.11.2 no alias
Description
With this command, you delete the name of the interface.
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 75
To Next Page
Loading...
Need help?
General
