Further notes
You disable the RADIUS server with the wlan security ap-radius-authenticator
command.
You display the setting with the show wlan security ap-radius-authenticator
command.
See also
wlan security ap-radius-authenticator (Page 499)
show wlan security ap-radius-authenticator (Access Point) (Page 496)
11.3.2.3 wlan security ap-radius-authenticator address
Description
With this command, you configure the IP address of the RADIUS server.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator address <index (1-2)> {ipv4
<ucast_addr> | fqdn-name <FQDN(100) | ipv6 <ipv6-addr>}
The parameters have the following meaning:
Parameter Description Range of values / note
index Index of the RADIUS server 1...2
ipv4 Keyword for an IPv4 address -
ucast_addr IPv4 address of the RADIUS server Enter a valid IPv4 address.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Domain Name) Maximum of 100 characters
ipv6 Keyword for an IPv6 address -
ipv6-
address
IPv6 address of the RADIUS server Enter a valid IPv6 address.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 501
To Next Page
Loading...
Need help?
General
