Network structures
7
7.1 WLAN
This section describes commands for configuring and managing wireless LANs (WLANs).
Some commands are available only in the "access point" or in the "client" mode. In these cases,
the titles have the term access point or client added to them.
Example: wlan mode
● wlan mode (access point): The function can only be used with access points.
● wlan mode (client): The function can only be used with clients.
7.1.1 The "show" commands
This section describes commands with which you display various settings.
7.1.1.1 show wlan advanced
Description
This command shows information about the send characteristics of the SCALANCE W700
device, for example the beacon rate, fragmentation.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan advanced <wlan 0/X>
The parameter has the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 185
To Next Page
Loading...
Need help?
General
