8.7.2.1 smtp-server
Description
With this command, you configure an entry for an SMTP server.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
smtp-server { ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6
<ip6_addr> } <receiver mail-address>
The parameters have the following meaning:
Parameter Description Note on the range if values
ipv4 Keyword for an IPv4 address -
ucast_addr IPv4 address of the SMTP server Enter a valid IPv4 unicast address.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
If you have stored a suitable do‐
main name, you can specify a host
name.
ipv6 Keyword for an IPv6 address -
ip6_addr IPv6 address of the SMTP server Enter a valid IPv6 address.
receiver mail-
address
Name of the recipient Maximum of 100 characters
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 29)".
Result
An entry for the SMTP server is configured.
Further notes
You delete an SMTP server entry with the no smtp-server command.
You store trhe domain name with the ip domain name or domain name command.
Network protocols
8.7 SMTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
438 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
