Requirements for changing to this mode:
● MSTP is enabled
● Base bridge mode: 802.1Q VLAN Bridge
● Compatibility mode: MSTP
7.3.5.1 instance
Description
With this command, you assign a range of VLANs to an MST instance.
Requirement
You are in the MSTP Configuration mode.
The command prompt is as follows:
cli(config-mst)#
Syntax
Call up the command with the following parameters:
instance <instance-id(1-64)> vlan <vlan-range>
The parameters have the following meaning:
Parameter Description Range of values / note
instance-id Number of the instance 1 ... 64
You can define up to 8 MSTP in‐
stances.
Default:
The VLANs 1 – 4094 are assigned
to instance "0"
vlan Keyword for a VLAN connection -
vlan-range Range of VLANs assigned to an in‐
stance
enter the range limts with a hyphen
or blank
Result
The range of VLANs is assigned to the MST instance.
Further notes
You cancel the assignment of the VLAN to an MST instance with the no instance command.
You delete the MST instance with the no instance command.
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 335
To Next Page
Loading...
Need help?
General
