Layer 3 functions
10
10.1 NAT
This section describes commands relevant for NAT / NAPT.
10.1.1 The "show" commands
10.1.1.1 show nat connections
Note
This command is only available in the client mode.
Description
This command shows the NAT connections in the form of a table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show nat connections
Result
The configuration and the translation list are displayed.
10.1.1.2 Introductory sentence to the section with the "show" commands
This section describes commands with which you display various settings.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 455
To Next Page
Loading...
Need help?
General
