7.1.1.9 show wlan client-list (access point)
Description
This command shows a table with the clients logged on with the access point as well as
additional information, for example status, signal strength, MAC address.
Note
The command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan client-list [wlan 0/X [{mac <macaddr> | sys <sysname> |
AID}]]
The parameter has the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
mac Keyword for the MAC address of the client -
macaddr MAC address aa:bb:cc:dd:ee:ff
sys Keyword for the system name of the client -
sysname System name
AID Connection ID of the client. -
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The table with the logged-on clients is displayed.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
192 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
