8.5.3.10 static-lease
Description
With this command you specify that devices with a certain MAC address or client ID are
assigned to the preset IPv4 address.
Requirement
● The assignment has not yet been created.
● You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
static-lease {mac <mac-address> | client-id <string>} <ip-address>
The parameters have the following meaning:
Parameter Description Range of values / note
mac Keyword for a MAC address -
mac-address Unicast MAC address Specify the MAC address.
aa:bb:cc:dd:ee:ff
client-id Keyword for a DHCP client ID -
string Freely definable DHCP client ID Enter the required designation.
Maximum of 254 characters
ip-address Unicast IPv4 address Enter a valid IPv4 address.
The IPv4 address must match
the subnet of the IPv4 address
band.
Result
The assignment is specified.
Further notes
You display the setting with the show ip dhcp dhcp-server bindings command.
You disable the IPv4 address band with the no pool-enable command.
You delete the assignment with the no static-lease command.
Network protocols
8.5 DHCP server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
404 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
