8.4 DHCPv6 client (IPv6)
This section describes commands for DHCPv6.
8.4.1 clear ipv6 dhcp client statistics
Description
With this command, you reset the counter to zero on the required interface.
Requirement
● DHCPv6 is enabled.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
clear ipv6 dhcp client statistics [interface {vlan <vlan-id(1-4094)>
|<interface-type> <interface-id>}]
The parameters have the following meaning:
Parameter Description Range of values / note
interface Shows that an interface description follows -
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
interface-
type
Type or speed of the interface Enter a valid interface.
interface-
id
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
If no parameters are specified, all counters are reset.
Result
The counter is reset.
Further notes
You enable DHCPv6 with the ipv6 address dhcp command.
Network protocols
8.4 DHCPv6 client (IPv6)
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
382 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
