5.7.3.4 no wlan iprp network
Description
With this command, you remove the VLAN assignment for PRP A and PRP B.
Requirement
You are in the WLAN iPRP configuration mode.
The command prompt is as follows:
cli (config-wlan-iprp-$)#
Syntax
Call up the command with the following parameters:
no wlan iprp network {A | B}
The parameter has the following meaning:
Parameter Description Range of values / note
network PRP Network A: PRP A
B: PRP B
Result
The VLAN assignment is configured.
Further notes
You configure the VLAN assignment with the wlan iprp network command.
5.8 AeroScout
SCALANCE W access points support tags of the AeroScout company. Tags are battery-
operated RFID sensors that send their data cyclically as multicast frames. They provide
information about temperature and movement and allow the user to send notifications.
Note
The command is only available when the following requirements are met:
● KEY-PLUG W780 iFeatures (MLFB 6GK5 907-8PA00)
● Access point mode
Functions specific to SCALANCE
5.8 AeroScout
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
152 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
