Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip domain lookup
Result
The DNS client of the device is disabled.
8.1.2.11 ip domain used server
Description
This command specifies which DNS server the device uses.
Note
Only resource records of type A (IPv4 address of a host) are supported.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip domain used server {learned-only | manually-only | all}
Network protocols
8.1 IPv4 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
352 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
