Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show spanning-tree detail
Result
The detailed settings for the spanning tree function are displayed.
7.3.1.5 show spanning-tree interface
Description
This command shows the settings of the ports for the spanning tree function.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show spanning-tree interface <interface-type><interface-id>
[{cost|priority|portfast|rootcost|restricted-role|
restricted-tcn|state|stats|detail}]
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
cost Shows the port costs used to calculate
the lowest-cost path.
-
priority Shows the priority of the port. -
portfast Shows whether spanning-tree
portfast is enabled.
-
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
304 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
