Siemens SCALANCE W770 Series User Manual

Syntax
Call up the command with the following parameters:
ntp server { ipv4 <ip_addr> | fqdn-name <Fully Qualified Domain
Name(100)> | ipv6 <ip6_addr> } [port { <1025-36564> | default}] [poll
<seconds(64-1024)>]
The parameters have the following meaning:
Parameter Description Range of values / note
id Number of the NTP server. 1 … 4
ipv4 Keyword for an IPv4 address -
ip_addr Value for the IPv4 address of the time
server
Enter a valid IPv4 address.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
If you have stored a suitable do‐
main name, you can specify a host
name.
ipv6 Keyword for an IPv6 address -
ip6_addr Value for the IPv6 address of the time
server
Enter a valid IPv6 address.
port UDP port of the time server 1025 … 36564
default Default value for the UDP port 123
poll Keyword for the time after which the
time of day is requested again
-
seconds Value for the time in seconds 64 … 1024
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface identifiers (Page 29)".
Result
The connection to a server is configured on the NTP client.
Further notes
You delete the connection to a server with the no ntp server command.
You store a domain name with the ip domain name or domain name command.
6.2.3.2 no ntp server
Description
With this command, you delete the connection to a server on the NTP client.
System time
6.2 NTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 175

Siemens SCALANCE W770 Series Specifications

General

Brand	Siemens
Model	SCALANCE W770 Series
Category	Wireless Access Point
Language	English