You display this setting and other information with the show spanning-tree mst
configuration command.
7.3.5.2 no instance
Description
With this command, you cancel the assignment of a VLAN to an MST instance or delete the
MST instance.
Requirement
You are in the MSTP Configuration mode.
The command prompt is as follows:
cli(config-mst)#
Syntax
Call up the command with the following parameters:
no instance <instance-id (1-64)> [vlan <vlan-range>]
The parameters have the following meaning:
Parameter Description Range of values / note
instance-id Number of the MST instance 1 ... 64
vlan Keyword for a VLAN connection -
vlan-range Range of VLANs that will be deleted
from the instance
1 ... 4094
Enter the range limits with a hy‐
phen or a space.
If you specify a VLAN or a VLAN range, the assignment to an MST instance is canceled.
If you do not specify a VLAN, the MST instance is deleted.
Result
The assignment of a VLAN to an MST instance is canceled or the MST instance is deleted.
Further notes
You assign a VLAN to an MST instance with the instance command.
You display this setting and other information with the show spanning-tree mst
configuration command.
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
336 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
